Line Toolbar

When you tap on an existing line or arc you will see the line toolbar appear near the bottom of your screen. The line toolbar contains functions that are frequently used on line or arcs in your Project. Following is an explanation of what each button will do.

	Set Figure Current Use this to make the current line or arc current in the Active Line List.
	End Figure Use this to mark a line as complete or finished.
	Reverse Figure Direction Use this to switch the direction of a figure so you can append to the opposite end.
	Partition Line / Arc You can partition (split) a figure or DXF line into smaller segments using this command.
	Delete Figure Segment Use this to delete a segment from a figure.
	Delete Entire Figure Use the delete an entire figure.
	Close Figure Use this to close a figure so it finishes at the same point it started at.
	Open Figure List Use this to display the Active Line List.
	Draw Tool Use this to draw lines, points, and connect line work between existing points. This will open the Draw Tool.
	Convert Line to Spline This will turn an existing figure that is comprised of straight lines into a curvy line, and vice-versa.
	Offset Tool Use this to open the Offset Tool.
	Stake Figure Use this to open the stake line command and stake the current line you have selected.
	Coordinate DXF Data You can add coordinates to the DXF entity by pressing the Coordinate DXF Data button.
	Information This will display the inverse information of the segment you have selected, as well as the perimeter and area if it is part of a closed figure.